I
NTRODUCTION
Supplied Accessories
owner's manual
(1EMN23999)
•
If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
•
Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters).
Contact your local electronics store for these items.
Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
1
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by "
stand and remove the stand from the unit slowly. Be careful not to drop the stand
when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
Symbols Used in this Manual
The following is the description for the symbols used in this manual.
Description refers to:
: Digital TV operation
DTV
•
If neither symbol appears under the function heading, operation is applicable to both.
4
EN
All manuals and user guides at all-guides.com
quick start guide
remote control
(1EMN24000)
(NF606UD)
2
Insert the stand all the way to the
main unit slowly until it clicks.
Make sure not to put the AC power
cord between the stand and the
unit.
", then lift the lever on the bottom
1
: Analog TV operation
TV
batteries
Phillips pan screw for
(AA x 2)
attaching the stand x 3
(FPH34100)
3
Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand with a screwdriver tightly.
screw holes
1
lever