Publicité
Les langues disponibles
Les langues disponibles
usEr insTrucTions
1.
Any repairs to this appliance should be carried out by qualified/authorized service personnel only.
2.
under no circumstances should this appliance be modified. Parts having to be removed for servicing must be replaced
with original "oEM" (original equipment manufacturers) parts only.
3.
this firebox is to be cleaned with a damp cloth (water) only.
iMporTanT: Always unplug the power cord before cleaning the unit. do not use any abrasive cleaners on the unit.
4.
unplug this firebox when not in use.
grounding instructions
this heater is for use on 120 volts. the cord has a plug as shown in figure 1A in the
diagram. An adapter as shown in figure 1C is available for connecting three-blade
grounding-type plugs to two-slot receptacles. the green grounding lug extending from
the adapter must be connected to a permanent ground such as a properly grounded
outlet box. the adapter should not be used if a three-slot grounded receptacle is
available. (note: Grounding adapter use prohibited in Canada)
locating your fireplace
When choosing a location for your new fireplace, ensure the general instructions are
followed. Also, for best effect install the fireplace out of direct sunlight.
It is safe to set the fireplace insert close to non-combustibles. Do noT sTorE or usE gasolinE or oThEr flaMMaBlE
Vapors or liQuiDs in ThE ViciniTy of This or any oThEr appliancE.
Mantel installation
Please refer to the detailed instructions that come with the mantel that you purchased.
specifications
Fireplace Insert dimensions
(w x d x h)
net Weight
Voltage
Frequency
Watts / Amps.
Heater Rating
Electrical connection
A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this appliance. Preferably, the fireplace
insert will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow
when the heater is in operation. the unit comes standard with a 6 ft (1.8 m) long 3 wire cord, exiting out the back of the fireplace
insert. Plan the installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum 14 ga,
3 wire with grounding type plug and connector and rated not less than 1875 watts. the extension cord shall not be more than 20
ft (6 m) in length.
28.3" x 9.4" x 20.1"
72 cm x 23.8 cm x 51 cm
28.7 lbs / 13 kg
120 V
60 Hz
1400W / 11.6A
4777 Btu's
Grounding Pin
Cover of Grounded outlet Box
C
Adapter
Grounding Lug
Metal Screw
Cover of Grounded outlet Box
A
B
3
Publicité
