Publicité
Initial Setup/Reset
IMPORTANT: You must RESET the desk before use.
Initial Setup / Reset:
1) When the LED display shows "
button until the desk reaches the lowest position and bounces up, the display shows the current
height, release the "
2) When the desk is in a static state, press and hold "
simultaneously and the desk starts reset process. Repeat the STEP 1 and then the reset is
completed. After that, the height you saved will be cleaned.
Quick Charge
Safe: Built-in over-temperature protection, over-current protection, short-circuit protection, etc., output
interface current-limiting protection can ensure that the product works within the normal current range;
Compatible: The product is compatible with mainstream smart phones and laptops on the market, and
can quickly charge the device.
Output Parameters:
1) Single USB Type-C port output: MAX 45W, 5V=3A, 9V=3A, 12V=3A, 15V=3A, 20V=2.25A;
2) Single USB Type-A port output: MAX 27W, 5V=2A, 9V=2A, 12V=1.5A, 15V=1.8A, 20V=0.9A,
compatible with Xiaomi CHARGE TURBO, Huawei FCP/SCP , Samsung AFC protocol;
3) When both Type-C and Type-A are connected to the device, the output voltage drops to 5V to power
the device, and the MAX is 22.5W.
4) Note: When the standing desk is lifting, the charging function will be turned o , and when the
standing desk stops lifting, the charging function will return to normal.
Up/Down:
The height of the desk can be adjusted up or down by pressing the "
current height will show on the display.
Setting Presets:
1) When the desk is in a static state, press and hold the button "
shows "
" , which means the save is successful. Then adjust the desk to any height. Click the
"
" button and the desk will adjust to the height you saved.
2) Buttons "
" , "
the above steps to save the height to the corresponding position. Then click the button and the
desk will adjust to the height you saved.
16
" , the desk starts the reset process. Keep pressing the "
" button and then the reset completes.
" , and "
" all have the same height memory function as button "
" and "
" buttons for 3 seconds
" or "
" for three seconds, the display
"
" button, and the
" , repeat
Publicité
