Publicité
3-5 Installing the LAN/COM/M.2 Kit
This system does not support the installation of both LAN/COM kit and 2.5" HDD; also the M.2 module
here cannot be equipped with a thermal plate due to the space limitation.
Follow these instructions to remove the WiFi Module:
Unscrew and remove the bracket, and then disconnect the SATA cable.
Install the upgrade kit board onto the bottom panel using the four screws provided, then
connect the cable included in the upgrade kit to the upgrade kit board.
套
Connect the other end of the cable to the SATA connector on the motherboard.
SATA
的
套
SATA
的
頭
System Hardware Installation
31
的
套
的 顆
的
Publicité
