Publicité
Les langues disponibles
Les langues disponibles
Make your contribution to environmentally friendly recycling!
According to the Electrical and Electronic Equipment Law and the Battery Law
(EletroG, BattG), erfal is obligated to take back controls, drives, other electrical accessories,
used batteries as well as accumulators free of charge and to recycle them properly. Costumers are
legally required to dispose used appliances and used batteries at designated collection points.
The delivery should always be in discharged state and protected against short circuits.
All manuals and user guides at all-guides.com
Electric accessories – Programming instructions | EN
Wireless tubular motor EAM24
Product description
Name:
Battery motor EAM24
Torque:
0,8 Nm
Speed:
34 rpm
Voltage:
12 V
Performance:
1.18 A
Radio frequency:
433,925 MHz
Capacity:
intern 650 mA / extern 2600 mA
Temperature range:
-10° / 55° Celsius
Protection class:
IP20
Conformiy:
Overview
Motor
ACCU-Pack
intern
Motor connection
Charging cabel
Battery connector
ACCU-Pack
extern
Antenna cable
Charging socket
Programming button P1
Motor connection
Programming instructions
You will receive a preconfigured sun protection product with preconfigured end positions.
A
Fine adjustment of the end positions
ATTENTION! Motor moves to continuous operation after longer keystroke! Urgently stop
before reaching the end position and then proceed through a tip.
Fine adjustement of upper end position
Press
1x run up and
Move to
UP + STOP
requested
down
for 5s
end position
Fine adjustement of lower end position
Press
Move to
1x run up and
DOWN + STOP
down
requested
for 5s
end position
Note
• eACCU-wireless-drives must be protected against shocks during transport, storage
and installation. Damaged components must be replaced.
• Please charge the battery full before the first use! Charging time approx. 6 hours. The
LED on the charger lights up red during charging and green when fully charged.
• Charging time approx. 6 hours. The LED on the charger lights up red during charging
and green when fully charged.
• Use the original chargers of the EAM-series for charging.
• The programming of the channels as well as the end positions are permanently
stored and remain even when the eACCU is completely discharged.
• The radio range is up to approx. 30 m in closed rooms.
• A minimum distance of 20 cm must be respected to avoid interferences when using
eACCU-wireless drives.
Up
Stop
Down
1 channel
Upper end
position is
Press
2x runs up and
readjusted
UP + STOP
down
for 2s
Lower end
position is
Press
2x runs up and
readjusted
DOWN + STOP
down
for 2s
Up
Stop
Programming
button P2
Down
Kanalwahl
CR2450
15 channel
Back
Programming videos
Watch online:
http://bit.ly/eACCU-Bedienungsanleitungen
Subject to technical change. 07 / 2019
04046046536109
Publicité
