Evermount EM-P3 Guide D'installation page 6

1) Make sure the flat panel display is not plugged in.
2) With the help of an assisitant ensure the flat panel display is supported while providing
access to the rear of the unit.
3) If screen has knobs on the back, remove them to allow the monitor brackets to be attached.
4) Place monitor brackets (BB and CC) on back of screen, align to holes, and center on back of
screen as shown in figure 2.1.
5) Attach the monitor brackets to the back of the screen using the appropriate combination of
screws, square washers, and spacers as shown in detail in figure 2.2 of the next page.
Notes:
● Top and bottom holes must always be used
● Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver
● The number of fasteners used will vary depending upon the type of screen
● "X" dimensions should be equal
All manuals and user guides at all-guides.com
Installing Monitor Brackets
CENTER BRACKETS
VERTICALLY ON BACK OF
SCREEN
CC
fig 2.1
X
BB
X
6