hager EE610 Mode D'emploi page 11

This device is to be installed only by a
professional electrician according to local
applicable installation standards.
Be sure to perform all manipulations
with the device switched off.
Installation
• Insert the cable into the cable grommet 1 in
order to facilitate access to the cables during
assembly.
• Screw the wall plate 2 to the wall using the
2 screws and wall plugs provided 3.
• Connect the wires as shown in the diagram
4. The earth terminal is used for earth wire
parking only.
• Clip the body of the lamp 5 onto the wall
plate 2 (a «click» confirms that the casing is
closed).
• Tighten the theft prevention screw 6 located
under the LED lamp.
• Carry out the adjustments (see pages 8 and 9).
• Put in place the cover 7.
Dismantling
• Place a flat screwdriver in the notch of the
cover 7 and push it towards the wall (~ 2 mm).
• Press the rear of the cover, rotate it and
remove.
• Loosen the theft prevention screw 6 located
under the LED lamp.
• Using a flat screwdriver, press in the upper
notch of the product.
• Remove the body of the lamp 5 from the wall
plate 2.
7
All manuals and user guides at all-guides.com
Installation
Dismantling
z