Acson international E Serie Manuel D'installation page 7

Wireless Remote Control
Indoor Unit
Air Discharge Louver
(behind the grille)
Front Panel
Preliminary Site Survey
Be sure to read this manual before installing the air-conditioner indoor unit.
• Electrical supply and installation is to conform to local authority's (e.g. National Electrical Board) codes and regulations.
Voltage supply fluctuation must not exceed + 10% of rated voltage. Electricity supply lines must be independent of welding
•
transformers which can cause high supply fluctuation.
• Ensure that the location is convenient for wiring, piping and drainage.
• Do not exert pressure on the resin parts when opening the unit or when moving it after opening.
• Do not move the unit from packaging while moving, until it reaches the installation site. Use safe material or protection
plates when unpacking it or lifting it to avoid damage or scratches to the unit.
• Check the following accessories are include with your unit:
a) Battery (2pcs)
b) Screw M6 x 40 (4pcs)
c) Washer, flat OD19 x ID17 x t1.0 (4pcs)
d) Screw M4 x 20 (2pcs)
e) Handset (1pc)
Obstacle
All manuals and user guides at all-guides.com
INSTALLATION DIAGRAM
Drain Hose
Air Filter
Air Discharge Louver
Air Intake
Air Intake
Air Discharge
INSTALLATION OF THE INDOOR UNIT
Min. 0.5m Min. 0.5m
Floor
Air Intake Grille
Refrigerant Piping
Remote Control
f) Screw M4 x 6 (2pcs)
g) Cover lock grille (2pcs)
h) Operation Manual (1pc)
i) Installation Manual (1pc)
j) Drain hose (1pc)
1-5
Outdoor Unit
Min. 0.5m