Conrad Sygonix Notice D'emploi page 32

"Temp"
Here you can enable and disable the temperature alarm and select °C or °F as a temperature
unit to be displayed. When the temperature alarm is enabled, the monitor outputs an alarm
if the temperature (measured by the wireless camera sensor (19)) is outside the fixed preset
range of +18 to +33 °C. The current temperature measurement appears on the top left of the
monitor display.
"Display"
In the top menu line you can select the time (30, 60, 90 seconds) after which the monitor switch-
es to standby mode to save power. A continuous display can also be activated.
In the bottom menu line you can select one of the three display brightness levels (20%, 50% or
90%). The right setting can be used for manual selection; after confirming the selection with the
"OK" button, the brightness can be adjusted using the "-" and "+" buttons. This manual setting in
the menu corresponds to that described in section 9. c).
"Language"
Here you can set the desired language.
Before changing language, make sure the wireless camera is connected to the volt-
age/power supply and is in operation. When you change language, not only the moni-
tor menu language is changed, but also that of the wireless camera voice messages.
"System"
• "Date/Time": Use this menu to set the date and time. In addition, you can select the display
format (e.g. DD MM YYYY = day/month/year), separator and time format (12/24 hours).
• "WifiSet": Check the setting, "EU" must be selected as the region.
Avoid using other settings ("FCC" = USA, "MKK" = Japan) as this can lead to radio
interference. Likewise, leave the channel default setting.
• "Reset": Here you can reset the monitor to the factory settings. Then check the region settings
(only "EU" is permitted, see previous point).
• "Sysinfo": The monitor shows the firmware version, the internal serial number and the previ-
ous operating time.
32