Lutron KETRA LS0 Guide D'installation page 4

Installing Fixed 45° Angle-Mounting Brackets
Note: For fixed 45° angle-mounting bracket installation do not use screws provided with original flat-mount backet,
only use the screws included in the angle-mount bracket kit.
1. LS0 segments attach to the mounting brackets on the underside of the luminaire. Determine location of mounting
brackets based on the center line of the segments keeping them centered along the length of the luminaire with
spacing no more than 2 ft (0.6 m) apart.
Luminaire Length
4 ft (1.2 m) or less
4.1 ft (1.2 m) - 6 ft (1.8 m)
6.1 ft (1.8 m) - 8 ft (2.4 m)
Note: Extra brackets are provided and can be used at the discretion of the installer.
2. Affix the flat-mount bracket to the angle-mount bracket using a hand tool, taking care not to over tighten.
3. Using the screws provided in the angle-mount bracket kit or #4 pan head screws suitable for the mounting surface,
mount the angle brackets to the surface.
Note: After mounting, confirm that the bracket is free to slide left and right (approx. 0.3 in [7.6 mm] overall).
4 | LS0 MOUNTING BRACKET INSTALLATION GUIDE
Required Brackets
2
3
4
P/N 3662881 Rev A
© 2023 Lutron Electronics Co., Inc. All rights reserved.