Publicité
Les langues disponibles
Les langues disponibles
Installing Flat-Mounting Brackets
1.
LS0 segments attach to the mounting brackets on the underside of the luminaire. Determine location of mounting
brackets based on the center line of the segments keeping them centered along the length of the luminaire with
spacing no more than 2 ft (0.6 m) apart.
Luminaire Length
4 ft (1.2 m) or less
4.1 ft (1.2 m) - 6 ft (1.8 m)
6.1 ft (1.8 m) - 8 ft (2.4 m)
Note: Extra brackets are provided and can be used at the discretion of the installer.
2.
Mount brackets to the surface with provided screws or using #4 flat head screws suitable for the mounting surface.
3.
When screwing mounting brackets to the surface, do not over tighten the screws. The bracket should be snug to the
surface but the center block should be able to rotate and slide up and down within the vertical slot.
Note: After mounting, confirm that the bracket is free to slide left and right (approx. 0.3 in [7.6 mm] overall).
Vertical Slot
P/N 3662881 Rev A
© 2023 Lutron Electronics Co., Inc. All rights reserved.
Required Brackets
2
3
4
Center block
3 | LS0 MOUNTING BRACKET INSTALLATION GUIDE
Publicité
