2
• The appliance is intended to be used for pools and spas for a specific purpose; it must not be used for any
purpose other than that for which it was designed.
• Always install the electric control panel away from humidity, rain and water projections. It must be installed in a
technical room or at least 3,5 meters of the swimming pool.
• Our products may only be assembled and installed in pools compliant with standards IEC/HD 60364-7-702 and
required national rules. The installation should follow standard IEC/HD 60364-7-702 and required national rules
for swimming pools. Consult your local dealer for more information
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.Children should be supervised to ensure
that they do not play with the appliance.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• The appliance must be installed according to the manufacturer's instructions and in compliance with local and
national standards and regulations.
• The electric control panel does not have to be used as a distribution box. Never connect external equipment to
the control panel.
• The power supply to the appliance must be protected by a dedicated 30mA Residual Current Device (RCD),
complying with the standards and regulations in force in the country in which it is installed.
• For electric control panels with 30mA differential circuit breaker, check regularly the safety system by pressing
the ''test'' button.
• The equipment does not include electrical switch for disconnection; include a disconnection supply device in
the fixing wiring at least OVC III, in accordance applicable national laws.
• Adjust the magneto thermal circuit breaker according to the real current consumed by the pump (see its
specification plate).
• Only a person qualified in the technical fields concerned (electricity, hydraulics or refrigeration) is authorized to
carry out installation, maintenance or repair work on the appliance.
• Never work on a control panel under tension. Cut main power before any intervention.
1. Technical specifications
Models
Dimensions
(cm)
Power supply
Input current
Working
frequency
Weight
IP rating
Compatible
filter pumps
Lighting
control
INSTALLATION AND MAINTENANCE
Command Connect Compact
31 x 23,3 x 12,7
7.5A
3,508
5,545
Motor protection
4.0-6.3A
12V
12V
100 VA
200 VA
C4
C6
protection
protection
protection
GENERAL WARNING
ELECTRICAL WARNING
230 V / 400 V (3ph+N+PE)
11A
50Hz
3,517
5,558
IP54
Motor protection
6.3-10.0A
12V
12V
100 VA
200 VA
C4
C6
protection
protection
Command Connect - English
Command Connect Advance
40 x 25,5 x 14,1
7.5A
4,309
6,15
Motor protection
4.0-6.3A
12V
12V
100 VA
200 VA
100 VA
C4
C6
protection
protection
11A
4,319
6,2
Motor protection
6.3-10.0A
12V
12V
200 VA
C4
C6
protection