Publicité
Electrostatic Discharge
Immunity
Radiated Immunity
Electrical Fast Transient
Weight / Dimensions
Cooling Method
Altitude
Dimension and Installation
Product Outlook and Dimensions (Units: mm, [ ]: inch)
Back Panel
6-Pin Terminals:
Wire Gauge:12-24 AWG / Torque:4.5 lb.-inch
Mounting Dimensions (Panel Cutout)
Installation
Please insert TP08G to the opening hole of panel and tighten the screws. However, if a firm mounting TP08G
to the panel is needed, please use the mounting fixed support accessory which is packed together with TP08G,
then insert the fixed support in the back and tighten the screws. Please refer to the following sections for
correct installation. (
The screw torque should be 4-5(kg-cm). DO NOT exceed this specification when tightening the screws;
otherwise TP08G may be damaged.)
Notes: Only the front panel is guaranteed by ingress protection rating. The control panel itself must comply
with the testing conditions required by the applied ingress protection rating.
Do not install and mount TP08G in the following environment.
A location subjected to Airborne dust, metallic particles, oil and smoke, corrosive or flammable
gases and liquids.
A location where temperature and humidity will exceed specifications.
A location where vibration and shock will exceed specifications.
0.43kg; 210×122×45mm (Width(W) × Height(H) × Deep(D))
If the fixed support is not installed well, Delta will not guarantee the waterproof function.
EN61000-4-2
EN61000-4-3
EN61000-4-4
Natural Air Cooling
0~2000 meters
Front Panel and Right Side Diagram
210 [8.2677]
Vertical View
196.26 [7.7266]
45 [1.7717]
Publicité
