Publicité
Les langues disponibles
Les langues disponibles
Installation Preparation
PREPARE DISHWASHER ENCLOSURE
This Wall Area
must be Free
of Pipes or
wires
+
34-1/2" 1/4"
Underside of
Countertop
to Floor
Plumbing and Electric Service
Must Enter Inside This Area
Figure A
• The rough cabinet opening must be at least 24" deep, 24"
wide and approximately 34-1/2" high from floor to underside
of the countertop.
DRAIN REQUIREMENTS
• Follow local codes and ordinances.
• Do not exceed 12' distance to drain.
NOTE: Air gap must be used, if waste tee or disposer
connection is less than 18" above floor to prevent siphoning.
DETERMINE DRAIN METHOD
The type of drain installation depends on the following
questions.
Do local codes or ordinances require an air gap?
■
Is waste tee less than 18" above floor?
■
If the answer to either question is YES, Method 1 MUST
be used.
• If the answers are NO, either method may be used.
CABINET PREPARATION
• Drill a 1-1/2" diameter hole in the cabinet wall within
the shaded areas shown in Figure A for the drain hose
connection. The hole should be smooth with no sharp edges.
IMPORTANT –
connecting drain line to disposer,
check to be sure that drain plug has
been removed. DISHWASHER WILL
NOT DRAIN IF PLUG IS LEFT IN PLACE.
All manuals and user guides at all-guides.com
24"
Min.
4"
Cabinets
Square
and
6"
Plumb
24"
Min.
When
1871 Art1
WARNING:
To reduce the risk of electric shock, fire, or injury to persons, the
installer must ensure that the dishwasher is completely enclosed at
the time of installation.
ADVERTENCIA:
Para reducir el riesgo de descarga eléctrica, incendio o lesiones a
personas, el instalador debe asegurarse de que el lavaplatos esté
completamente cerrado en el momento de la instalación.
• The dishwasher must be installed so that drain hose is no
more than 12' in length for proper drainage.
• The dishwasher must be fully enclosed on the top, sides and
back, and must not support any part of the enclosure.
CLEARANCES: When
installed into a corner,
allow 2" min. clearance
between dishwasher
and adjacent cabinet,
wall or other appliances.
Allow 28-3/8" min. clear-
ance from the front of
the dishwasher for door
opening. Figure B.
661Dia42
Method 1 – Air Gap with Waste Tee or Disposer
An air gap must be used when required by local codes and ordi-
nances. The air gap must be installed according to manufacturer's
instructions.
Drain Hose Hanger
Remove
Drain
Plug
Method 2 – "High Drain Loop" with Waste Tee or Disposer
Tip: Avoid unnecessary service call charges.
05D-1294B
Always be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
Countertop
Dishwasher
Clearance for Door
Opening 2" Minimum
Figure B
756Dia30
Figure C
661Dia43
Drain Hose Hanger
32"
Min.
18"
Min.
Figure D
923-40B
28-3/8"
32"
Min.
18"
Min.
3
Publicité
