EcoSmart Fire Ark 40 Manuel D'installation page 3

ENGLISH
Fireplace
Installation
1. Insert the metal tray into the base.
2. For Indoor Installations insert the Indoor
Safety Tray. The appliance must not be
operated indoors without the Safety Tray
installed.
For outdoor installation go to Step 3.
3. Insert Burner into metal tray.
All manuals and user guides at all-guides.com
4. Insert Glass Screen. Refer to instructions in
glass screen packaging.
Appliance must not be operated without the
glass screen installed.
5. Add glass charcoal around the burner - be
careful not to scratch the burner surface.
Do not place glass charcoal on top of the
burner or where they can interfere with the
operation of the burner or the flame.
6. For models that have a fixed cosmetic plate
pre-installed please proceed to Step 10.
Otherwise please move to Step 7.
7. Insert two clips into the top and bottom of
the control panel. (Four clips are supplied
but only one or two will be needed in most
cases).
8. Insert the cosmetic cap into position.
9. If you find it too loose - add an additional
clip to the side/s to tighten up the fit, if it's
too tight - remove one of the clips until the
best fit is achieved. The remaining part
(similar to the cosmetic plate) packed with
your unit is not required for bioethanol
fuelled installations.
10. These models come with Ground Fixing
Brackets so they can be installed in a
fixed position. Follow the instructions
supplied with the Ground Fixing Brackets
to complete the installation of the product.
OPERATE ACCORDING TO THE BURNER
OPERATIONS MANUAL INCLUDED WITH
THE BURNER.
© Copyright 2004 - 2020 MAD Design Group. All rights reserved. V1119