Publicité
Les langues disponibles
Les langues disponibles
WARNING: Do not expose the heating elements or switches to water, cleaning liquids or
other chemicals, as fire, electrical shock, personal injury and properly damage can occur.
CAUTION: Do not use gasoline, benzene or thinner to clean your heater, as these chemicals
can cause surface damage.
2. Use a vacuum cleaner with a crevice tool to remove dust from the interior or your heater.
3. Use a clean, soft and lightly damp cloth to gently wipe the surface of the enclosure.
4. Allow the enclosure to dry completely prior to operating you heater.
OFF-SEASON STORAGE INSTRUCTIONS: Secure the power cord, and place your heater in its
original shipping container, or a similar container. Store the container in a cool, dry
location.
SAFETY FEATURES
TIP-OVER PROTECTION
Your heater is equipped with a Tip-Over Safety Switch. When your heater tips over, it will
turn off automatically.
OVERHEAT PROTECTON
Your heater is equipped with an Overheat Protection System. When the threshold
temperature has been reached, your heater will turn off automatically.
*To reset your heater after the Overheat Protection System has been activated:
1.
Turn the Power Control Switch to the 'O' position and turn the Temperature Control
Switch to the lowest setting.
2.
Disconnect the power cord from the electrical outlet. Allow your heater to cool down
for approximately ten minutes.
3.
Ensure that both the intake and the exhaust vents are clear of obstructions.
4.
Connect the power cord to the electrical outlet.
5.
Turn the Power Control Switch to the 'II' position and turn the Temperature Control
Switch to the highest setting.
6.
If your heater does not operate normally, turn the Power Control Switch to the '0' position,
disconnect the power cord from the electrical outlet, and consult an authorized repair
technician.
TROUBLESHOOTING: Review this manual to ensure that you understand the basic operations
and features of your heater.
1.
Check your household circuit breaker or fuse.
2.
Check for obstructions at the intake and exhaust vents.
•
If obstructions are present, refer to the instructions for resetting your heater when
the Overheat Protection System has been activated.
•
If no obstructions are present, and your heater still does not operate normally, turn
the Power Control Switch to the '0' position, disconnect the power cord from the
electrical outlet, and consult an authorized repair technician.
5
Publicité
