Portfolio 598-1165-03 Mode D'emploi page 2

INSTALLATION
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit
breaker.
1. Remove
two nuts.
3. Tighten screws
finger tight.
4. Attach mounting
plate to junction box.
Horizontal Junction Boxes Only:
Fixture
Screw
Remove ground screw and 2 fixture screws
from the mounting plate. Flip plate over.
Re-insert ground screw. Insert the 2 fixture
screws in the holes near the junction box
screw holes. Wire path must be located as
shown above.
Get user manuals: See SafeManuals.com
2. Remove
Mounting Plate.
Ground
Screw
Wire Path
Ground
Screw
Wire
Path
Fixture
Junction
Screw
Box
Screws
WIRING
BLACK
WHITE
One Motion Light
BLACK
WHITE
Two Motion Lights
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green "pigtail". If you are unsure about
the grounding method, consult your local
building code.
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Recommended Grounding Method
Use a green ground "pigtail" (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the "pigtail"
with the GND screw on the mounting plate.
Black to black
2
BLACK
White to white
598-1165-03