Publicité
Les langues disponibles
Les langues disponibles
Step 5 Programming
NOTE: The unit must have an enrolled user before it can be
programmed to the receiver. Due to the 30 second time interval,
a second person may be needed to press the "SMART" actuator.
1. Remove the front panel of the receiver
case. Press and release the "SMART"
actuator on the receiver. The "SMART"
indicator light will glow steady for 30
seconds.
2. Open the Fingerprint Keyless Entry
cover and wait for Ready LED to light.
3. Within 30 seconds of pressing the
"SMART" actuator, slowly and firmly swipe
enrolled finger.
NOTE: The Retry LED will light if another
swipe is needed.
4. After a passed swipe, the Pass LED will light
followed by a lit Send LED. Programming is
complete.
5. If the opener does not operate, press and
release the Resend button at 1 second
intervals for up to 5 seconds until the door
moves. Programming is complete.
NOTE: If unit will not program to opener,
repeat the steps above or refer to
Troubleshooting.
Step 6 Operation
1. Open cover and wait until Ready LED
is lit.
2. Swipe finger slowly and firmly down the
sensor strip.
3. The Pass LED will flash and garage door
will either open or close.
NOTE: If cover is already open, press either the Resend or the
2
Enroll button to turn unit on. The Fail or Retry LED will light if
another swipe is needed. If this occurs, swipe slowly and with
ENROLL
more pressure. It may require multiple swipes to get a passed
SEND
ENROLL
PASS
FAIL
swipe.
READY
RETRY
While the door is traveling, the Send LED will be lit. During this
time, the only way to reverse or stop the door is to press the
3
Resend button.
4
SEND
ENROLL
PASS
FAIL
READY
RETRY
5
3
1
ENROLL
SEND
ENROLL
PASS
FAIL
READY
RETRY
2
3
SEND
ENROLL
PASS
FAIL
READY
RETRY
Publicité
