Bestway LAY-Z-SPA S100101 Manuel De L'utilisateur page 14

direct sun light exposure by a cover when not in use.
Follow the important instructions above to choose the correct
surface and location to set up your spa. Damaged parts of
the spa, due to the fact that the set-up surface and location
does not match the instructions, will not be considered as
manufacture defect and will avoid the warranty and any
service claims. It is the responsibility of the owner to ensure
the site meets the requirements at all times.
• Consult your local professional installers for environmental
conditions, such as ground water and risk of frost.
• Recommended to protecting the spa from direct sunlight
exposure by a cover when not in use.
SPA HEATER EQUIPOTENTIAL BONDING TERMINAL
• It is recommended to arrange for a qualified electrician to
connect the spa pump to an equipotential bonding terminal
using a minimum 2.5mm
HEATING RESET
• When using the Lay-Z-Spa for first time,
or after a long period of inactivity, be
sure to press the reset button on the
pump using a small and thin object.
• If the temperature on the control panel
(or the water temperature) has not
changed for 4-5 hours after activation of the heating system,
use a thin object to press the RESET BUTTON, and restart
the heating system.
• If the Lay-Z-Spa is under direct sunlight and the outside
temperature is above 35ºC there is a risk that the heating
system will not operate, and the display will show the alarm
code E08. Under these conditions, please wait until a cooler
time of day before pressing the RESET BUTTON with a thin
object and restarting the heating system. If the spa remains
in the same position, the alarm E08 can appear again. In that
case follow the same procedures.
solid copper conductor.
2
14
Reset