weinor BiConnect BiSens Agido-3V Mode D'emploi page 10

BiConnect BiSens Agido-3V
Setting the sensitivity level
The threshold value in the product protection sensor
can be adjusted inside the device using a screwdriver.
The threshold values range from 1 (very sensitive;
reacts to light breeze) to 10 (low sensitivity; only reacts
to gusts). If the sensor should be deactivated, simply
remove the batteries.
The factory setting for the sensor is threshold value 4.
Service information
The radio control is normally per-programmed when
delivered. Once the awning is connected to the power
supply, it can be operated directly from the hand trans-
mitter.
After connecting the awning to the power supply, it is
important to check that the hand transmitter and all the
supplied sensors are working:
Can all the components be operated (awning,
-
valance; lights, if installed) using the hand transmit-
ter?
Are all the sensors programmed correctly?
-
- Simulating "wind" by the sun/wind (or
sun/wind/rain) sensors  Awning retracts
- "Shaking the drop profile"  Awning retracts
In rare cases or in case of servicing, the radio control
must be initialised on site.
Initialising the BiSens Agido-3V product protection
sensor (if not already preset before leaving the
factory)
To use the BiSens Agido-3V product protection sensor,
all other BiConnect components must already have
been properly initialised. Take special care to ensure
that the awning can be extended and retracted using
the hand transmitter.
If a conventional sun/wind sensor is installed this must
also have previously been initialised. After the WIND
key (= UP key) is pressed, the sun protection unit must
retract upwards (into the housing). After the SUN key (=
DOWN key) is pressed, the sun protection unit must
extend down (into the sun protection position).
Item number 117879-0000
Version 2 2014-09-01
All manuals and user guides at all-guides.com
We reserve the right to make technical changes
Page 2/4
1. Open the housing
Familiarise yourself with all the operating elements in
the Agido-3V.
UP key (wind)
P key
DOWN key (no wind)
Threshold adjuster
Indicator light
After pressing the UP or DOWN key, the indicator light
2.
will indicate what status the Agido-3V is in.
Indicator Meaning
light
Orange (1x) Agido-3V is in bidirectional mode;
Agido has been programmed or
can be paired to a bidirectional
receiver.
Orange light Agido-3V is not paired to a receiv-
flashes (4x) er. The sensor can be paired
bidirectionally or unidirectional-
ly, depending on the receiver.
Orange light Agido-3V is now being paired
flashes fast bidirectionally. A pre-programmed
(6x) receiver can only be used after it
has been paired to a device.
Green Agido-3V is in unidirectional mode
and can only be paired to a unidi-
rectional receiver.
3. The first time it is to be programmed, the Agido-3V will
decide whether it should run unidirectionally or bidirec-
tionally. Alternatively, the operating mode can be
selected when inserting the batteries.
Hold down the Wind key
and insert the
batteries.
Bidirectional
mode selected;
Standard setting
for awning oper-
ated using a
BiEasy hand
transmitter.