Porter&Charles CC60V Instructions D'installation page 11

All manuals and user guides at all-guides.com
Turn On and Turn Off The Appliance
If the appliance is in Stand-By-Mode, it is put in Operating-Mode by pressing
the On/Off button at least 1 second. A buzzer signal indicates the
successful operation acoustically.
On all zones a ´0` appears and all Decimal Points of the zone flashes (1
sec on, 1 sec off).
If there is no operation within 10 sec, the display of all zones will turn off.
If the displays are turned off, the zone will be set into Stand-By-Mode.
If is pressed more than 2 sec (in Operating-Mode), the appliance is
switched off and is set into the S-Mode again. The appliance can be turned
off by pressing at any time; even if other buttons are pressed
simultaneously.
If there is a residual heat of a heater remaining, this will be indicated in the
correspondent heat setting Zone Display.
Select Zone
If a single zone is chosen with the corresponding zone Active/Deactive
Zone Button , the Decimal Point of the related Heater Display flashes.
selected heater you can set the heat level between 1-9 by touching the
,
For the
Heat Setting Slider Buttons
The slider button must be pressed within 3 sec, otherwise the zone selection
is erased and heat setting dot will disappear (Decimal Point). If there is no
further operation within 10 sec, the heater falls back into the S-Mode.
The heat setting can always be changed by pressing between
level 1-9.
Each sliding operation or each display change is quitted by a buzzer signal.
10