GE 29869 Mode D'emploi page 5

Introduction
CAUTION: When using telephone equipment, there are basic safety
instructions that should always be followed. Refer to the IMPORTANT
SAFETY INSTRUCTIONS provided with this product and save them for
future reference.
Before You Begin
Parts Checklist
Make sure your package includes the following items:
MESSAGES
PREVIOUS NEXT
STOP
PLAY PLAY
2 4
PLAY
3
1
PLAY
Answerer
Modular Jack Requirements
You need an RJ11 type modular jack, which is the most common type of phone jack
and might look like the one pictured here installed in your home. If you don't have a
modular jack, call your local phone company to find out how to get one installed.
Installing the Battery
In the event of a power loss, a 9-volt battery (not included) enables the
answerer to retain greetings and messages stored in memory. To install
the battery:
1. Remove the battery compartment door on the bottom of the unit by
loosening the screw with a Phillips screwdriver. Lift the door.
2. Connect a fresh 9-volt alkaline battery (not included). The large
and small contacts on the battery clip and the battery will interlock. Once
connected, place the battery inside the battery compartment.
3. Replace the battery compartment door and tighten the screw.
NOTE: If the battery is low or not installed, the unit announces
"Low Battery" at the end of message playback.
All manuals and user guides at all-guides.com
MIC
AC power supply
Telephone line cord
Battery
compartment
door
Battery
Wall plate
Modular
telephone
line jack
Battery clip
-
+
-
+
5