Samsung 7 Serie Mode D'emploi page 7

Initial Pairing
IR receiver
30cm ~ 4m
TV STB BD
RETURN VOICE NUMBER
After you have run the Initial Setup on your TV, you should connect your Smart Touch Control to your TV.
1. Point the Smart Touch Control toward the IR Sensor of the TV and press any key on the Smart Touch Control.
2. The connection icons appear on the bottom left of the screen, and the TV connects to your Smart Touch Control automatically.
✎
If you want to perform the pairing process again, press the reset button in the centre of the back cover using a pin or the tip of an unbent
paper clip. The Smart Touch Control will be initialized.
Calibrating the Touch Pad
To calibrate the Touch Pad on the Smart Touch Control, follow these steps:
1. Press the NUMBERš button for 3 seconds. The calibration starts.
2. When done, all the LEDs on the top of the Smart Touch Control blink twice simultaneously.
✎
While calibrating, don't touch the Touch Pad.
✎ If the Touch Pad looses accuracy, re-calibrate the Touch Pad by repeating Steps 1 and 2.
To display the shortcut functions list on the bottom of the screen, press the
Source, CH List, 3D and other functions.
To display the colour and playing control functions on the top of the screen, press the
RETURN VOICE NUMBER
RETURN VOICE NUMBER
All manuals and user guides at all-guides.com
<Connecting>
• Smart Touch Control PAIRING Reset button
Using the Touch Pad
‹
To Move the Highlight: Rest your finger on the Touch Pad, and then slide it from one side to the other, from top
to bottom, or bottom to top.
✎ To move the Highlight continuously, flick your finger across the Touch Pad from right to left, left to right,
top to bottom, or bottom to top.
To Select an item: Press the Touch Pad.
English - 7
TV STB BD
• Smart Touch Control
RETURN VOICE NUMBER
<Pairing complete>
button at the bottom of the Touch Pad. This list include Menu,
button on the top of the Touch Pad.