Fellowes POWERSHRED 70S Mode D'emploi page 3

BASIC SHREDDING OPERATION
PAPER OR CD/CARD
1
Continuous operation:
10-12-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Plug in and put
Continuous operation beyond
disconnect power
10-12-minutes will trigger
switch in ON (I) position
20-minute cool down period.
TROUBLESHOOTING
A B C
PAPER JAM
1 2
Press and hold Alternate slowly back and forth
Reverse (R)
All manuals and user guides at all-guides.com
2
Check paper amount
Press Auto-On (I)
4
3
Set to Off (O)
and unplug
3 4
14
14
Feed paper straight into
paper entry and release
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
B. Bin Open: The shredder will not run if the bin is open.
When illuminated, close the bin to resume shredding.
C. Remove Paper: When illuminated, press reverse (R) and remove paper.
Reduce paper quantity to an acceptable amount and refeed into paper entry.
5
6
14
Gently pull uncut
Press and hold
paper from paper
Reverse (R)
entry. Plug in.
5 6
or
14
Feed into card/CD When finished
entry and release shredding set
to OFF (O)
3