Publicité
Les langues disponibles
Les langues disponibles
160992A1SS.qxp_GSA18V-083 2/8/16 1:17 PM Page 9
PROTECTION AGAINST DEEP
DISCHARGING
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty,
the tool is switched off by means of a
protective circuit.
Do not continue to press
the trigger switch after
the tool has been automatically switched
off. The battery can be damaged.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
SWITCH LOCK
Your tool is equipped with a switch lock
located above the trigger. This lever is
designed for locking the trigger in the "OFF"
position to help prevent accidental starts and
accidental battery discharge.
To lock the trigger, press the lock ( ) side of
the switch lock until it clicks (Fig. 5).
FIG. 5
SWITCH
LOCK
1. Securely clamp the work.
2. Mark the line of cut and grasp the tool with
one hand on the handle and the other
placed on the insulated rubber boot over
the front housing.
Always hold the saw by the
insulated boot on the front
housing. If you saw into a blind area where
live wiring exists, you may be shocked or
electrocuted.
All manuals and user guides at all-guides.com
Operating Instructions
controlled trigger switch. The tool can be
turned "ON" or "OFF" by squeezing or
releasing the trigger. The blade plunger stroke
rate can be adjusted from the minimum to
maximum nameplate stroke rate by the
pressure you apply to the trigger. Apply more
pressure to increase the speed and release
pressure to decrease speed.
Your tool is equipped with an LED work light
that turns on automatically when the trigger
switch is activated. When the tool is turned
off, the light turns off (Fig. 1).
position whenever the tool is not being
used.
To unlock trigger, press the unlock ( ) side of
the switch lock until it clicks (Fig. 6).
FIG. 6
VARIABLE SPEED
TRIGGER SWITCH
Using the Saw
3. Keep the saw footplate firmly against the
4. Squeeze the trigger to start the tool. Let the
Following a few simple tips will reduce the
wear on the workpiece, the tool and the
operator.
-9-
BUILT-IN LED WORK LIGHT
Always move the switch
lock
to
VARIABLE SPEED
SWITCH
TRIGGER SWITCH
LOCK
work to minimize counter-force (jumping)
and vibration.
saw reach full speed before starting the cut.
Guide the saw so that the blade will move
along the marked line.
SAWING TIPS
the
locked
Publicité
