emerio HF-106631.1 Mode D'emploi page 15

2. Fill the water into the water tank, and then tighten the tank cover.
3. Put the water tank on the main body.
4. Check if the rated voltage meets the input voltage, and plug in the electric socket.
5. Switch on the appliance; the background LED light will light up. The appliance begins to work.
6. Press the button "MAX" or "MIN"; you may adjust the mist volume on the remote control by pressing
the button of "MIST VOLUME".
7. Press the button "Ion", the ionizer works. It shows the shape of trees on the LED display. Press the
button "Ion" again to stop the function.
8. Constant humidity: Before pressing the button "HUMIDITY", LED display shows the current humidity.
You may set the humidity range from 45%RH to 90%RH. Press once; it will increase by 5%RH. When it
reaches 90%RH, press again, it will return to 45%RH. After you set the expected humidity, the appliance
will keep the memory after 5 seconds. 5 seconds later, LED display shows the current humidity. If the
expected humidity is less than the current humidity, the appliance will stay in sleeping mode. But if the
expected humidity is higher than the current humidity, the humidify function will work.
9. Timer setting: There are 12 timer settings: 1,2,3,4,5,6,7,8,9,10,11,12 hours. Press the button "TIMER",
then the icon "Timer" flashes on the LED display. The timer shows the rest operation time and decrease
by 1 minute, i.e., if you set the timer for 12 hours, LED display shows 11:59 after one minute.
10. Once you have set the automatic function, it will count by the timer. The desired relative humidity and
the actual relative humidity will be displayed 40 seconds alternating in the middle of LED display.
11. If there is not enough water in the basin, the appliance will automatically stop working. Nothing will be
displayed on the LED. The unit will restart again after refilling the water.
1) Take the water tank out of the unit, open the water tank cover, and fill the tank with clear water.
Close the cover, and put the tank back to the base unit carefully.
2) Put the nozzle into the socket on top of the water tank.
3) Connect the mains supply, switch on the unit (NEVER RUN THE UNIT WITHOUT WATER IN WATER
BASIN). The control lamp will light up. The unit starts working.
12. Please use the appliance on maximum relative humidity (90% RH) only, if you want a high humidity like,
for example, in greenhouses / or to grow orchids, because there is an intended precipitation around the
device with this max. setting. Please adjust the humidistat in living rooms so that moisture around the
device will be avoided.
MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can
cause "white powder (limestone)" problem and may cause heavy sediments on the surface of the water
basin, transducer and inner surface of the water tank. Sediments on the surface of the transducer could
influence proper function.
We recommend:
1) Use cold boiled water or distilled water.
2) Clean the transducer, water tank and basin unit every week.
3) Change water in water tank frequently to avoid "white powder" / limestone.
4) Make sure to drain water out from the water tank and dry the water basin before storing the unit for a
long period of time.
5) Clean the whole unit, and make sure that all parts of the unit are dried completely before use.
All manuals and user guides at all-guides.com