Publicité
Les langues disponibles
Les langues disponibles
In order to minimize the potential of a shock hazard due to hazardous voltages, cover the entire solar
•
array with dark material prior to connecting the array to any equipment.
WARNING: Risk of electric shock. Unauthorized removal of necessary protections, improper use,
•
incorrect installation and operation may lead to serious safety and shock hazards and/or equipment
damage.
WARNING: Danger to life due to fire or explosion: electrical devices can cause fires.
•
Do NOT install damaged modules.
•
Do NOT install modules inside.
•
Do NOT install modules on moving objects.
•
Never step on the modules.
•
Do NOT subject the modules to mechanical stresses.
•
Do NOT drop objects on modules.
•
Do NOT drop modules.
•
Never lift or move the module through the connection cables or inverter.
•
Do NOT put any things on the inverter or the modules.
•
Do NOT cover the inverter or the modules.
•
Do NOT move the installation during operation.
•
Under special circumstances, the inverter may be subject to electromagnetic interference from
•
surrounding equipment. At this time, the user is obliged to take correct measures to reduce the
interference from surrounding equipment to the inverter.
Never install the inverter near the sensitive equipment (e.g. Radios, telephone, television,
o
etc).
Do not stay closer than 20 cm to the inverter for any length of time.
o
Electrical Warnings
All electrical installations must comply with local electrical safety standards.
•
Do NOT open the casing. Do NOT attempt to repair, consult qualified service personnel. All wiring and
•
electrical installation must be performed by qualified service personnel.
Improper operation during the wiring process can cause fatal injury to operator or unrecoverable damage.
•
ONLY qualified personnel can perform the wiring work.
Touching live components can result in serious injury or death.
•
Electrical installation, repairs and conversions may only be carried out by electrically qualified persons.
•
WARNING: Danger to life due to high voltages. Forbid installation in live line.
•
Do NOT touch damaged components.
•
Excessive voltage can damage the solar kit.
•
Do NOT disconnect the solar kit under load.
•
Do NOT disconnect the loaded cables.
•
Isolate all exposed cable ends.
•
Only connect cables with connectors
•
Make sure all electrical components are in a clean state, dry and secure
•
Make sure the cabling is not under tension
•
Ensure wiring is not exposed and/or hanging and is protected from dirt and mould
•
Ensure all connectors are sealed and secure during operation.
•
Publicité
