Allegion LOCKNETICS RS Serie Instructions D'installation

RS210/310 Electric Strike Installation Instructions
The RS210/310 Electric Strike is surface mounted and designed with the strength and durability for use with rim
exit devices with a 1/2" (RS210) or 3/4" (RS310) throw Pullman latchbolt. No cutting on the frame is required for
installation. Unit is field selectable for fail-safe and fail-secure operation, and for 12 or 24VDC. The RS210 has
a 1/2" (12.7mm) thick metal housing. The RS310 has a 3/4" (19mm) thick metal housing.
Dynamic Strength
Endurance Rating
Dual Voltage
Black
12 VDC
Red
White
Green
(Polarity Free)
(On select models)
WARNING
Warnings indicate potentially hazardous
conditions, which if not avoided or corrected,
may cause death or serious injury.
14°F to 120°F(-10°C~+49°C)
1500 lbs
70 ft-lbs
250,000 cycles
Field selectable fail-safe and
fail-secure Non-fire rated model
Overheated or burnt coils caused by incorrect voltage/wire
harness combinations will not be covered under warranty
RS310-LBM: 1.5A/40VDC
RS210-LBM: 0.3A/6VDC
Cautions indicate potentially hazardous
conditions, which if not avoided or corrected,
may cause minor or moderate injury. Cautions
may also warn against unsafe practices.
UL Requirements
• The RS210/310 series is intended to be used with UL Listed Exit
hardware
• The RS210/310 series shall not impair the intended operation of
an emergency exit
• The RS210/310 series shall not impair the operation of panic
hardware mounted on the door
UL294
Performance Level
White
24 VDC
Green
Black
Red
(Polarity Free)
CAUTION
CAUTION
Destructive Attack: Level I
Line Security: Level I
Standby Power: Level I
Endurance: Level IV
NOTICE
Notices indicate a condition that may cause
equipment or property damage only.
24 VDC