Publicité
Les langues disponibles
Les langues disponibles
Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Error
Message
No pot or pot not suitable;
ER03
Water or pot on the glass over the control
The connection between the display board and the
F1E
left mainboard is fail (the cooking zone which
indicator showing "E")
Coil temperature sensor failure. (the cooking zone
F3E
which indicator showing "E")
Mainboard temperature sensor failure. (the cooking
F4E
zone which indicator showing "E")
Temperature sensor of the ceramic glass plate is
E1E
high
Temperature sensor of the IGBT is high
E2 E
Abnormal supply voltage(too high)
E3 E
Abnormal supply voltage (too low)
E4 E
Temperature sensor failure(the cooking zone which
E5 E
indicator showing "E")
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages
to the induction hob and
All manuals and user guides at all-guides.com
Possible Cause
please contact the supplier.
Replace the pot;
Clean the user interface
1.Connection cable not correctly plugged or
defective;
2.Replace the Mainboard.
Replace the coil sensor
Replace the mainboard
Please restart after the induction hob cools
down.
Please restart after the induction hob cools
down.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Connection cable not correctly plugged or
assemble defective;
17
What to do
Publicité
