Publicité
Les langues disponibles
Les langues disponibles
Each burner flame has been factory set to the lowest position
available to provide reliable and constant reignition of the burner.
However, each burner can be adjusted.
NOTE: If your model number begins with KGCS5 or KGCS9, call
service, because this operation will require opening the unit.
To Adjust:
The flame can be adjusted using the adjustment screws
underneath the control knob.
NOTE: Check the Use and Care Guide for information on each
burner to determine whether they are single or dual flame. Adjust
the valves accordingly.
Adjustment for Single Valve
1. Set the burner flame to LO.
2. Remove the control knob.
3. Hold knob stem with a pair of pliers. Use a ³⁄₃₂" (#0 [2.0 mm])
flat-blade screwdriver to turn the screw located within the
shaft of the control knob stem until the flame is the proper size.
A
B
C
³⁄₃₂
A.
" (#0 [2.0 mm]) flat-blade screwdriver
(screwdriver shaft must be a minimum of
2" [5.1 cm] long)
B. Control knob stem opening
C. Adjustment screw location
4. For LP gas conversion:
Completely tighten screw "C" to set the minimum flame
height.
For Natural gas conversion:
Tighten screw "C" to reduce flame height. Loosen screw to
increase flame height. See "Complete Burner Adjustment"
section.
5. Replace the control knob.
6. Test the flame by turning the control from LO to HI, checking
the flame at each setting.
Flame Height Adjustment
Adjustment for Dual Valve
To Adjust Inner Crown Flame:
1. Set the inner crown flame to LO.
2. Remove the control knob.
3. Remove the black rubber grommet.
4. Using needle-nose pliers, remove the gray shield inside the
burner valve opening.
5. For LP gas conversion:
Completely tighten screw "A" to set the minimum flame
height.
For Natural gas conversion:
Tighten screw "A" to reduce flame height. Loosen screw to
increase flame height. See "Complete Burner Adjustment"
section.
6. Replace the control knob.
A. Inner crown
B. Outer crown
A. Control knob
B. Black rubber grommet
C. Gray shield
A
B
A. Inner crown adjustment screw
B. Outer crown adjustment screw
A
B
A
B
C
7
Publicité
