FRIGOGLASS Super 800 HC Manuel D'utilisation page 12

ENG
Mains connection: If the mains cord supplied is not long enough, do not use an extension lead and do
not replace it. Ask an authorized electrician to replace the cord with a longer one.
c. The merchandiser must stand upright for at least 1 hour after transportation and prior to start up.
This gives the oil time to run back to the compressor after transit and installation.
d. Allow a minimum gap of 100mm at the top. The cooler must also have a 44mm distance from
the back (metal spacers) for proper ventilation. Do not place anything on top of the ICM.
3.2 Adjusting the shelf
To adjust the shelf first unload it, lift it and unclip the shelf clips (4). Place the clips in the desired
position and reposition the shelf. Make sure that the horizontal metal rods at the bottom of the shelf
are between the front and back shelf clips.
12
Do not place the merchandiser:
•
in direct sunlight or near heat sources (radiators, stoves & other
heating equipment)
•
outdoors, without proper protection from rain, moisture and other
atmospheric elements
•
in weather conditions for which it is not certified
•
in extreme environmental conditions (i.e. extensive exposure to
saline humidity)
•
Do not place the cooler on a tilted surface with an angle bigger
than 5°.
Keep the ventilation openings, both in the appliance enclosure and in the
built-in structure, clear of obstruction.
Do not damage the refrigeration circuit