Publicité
Les langues disponibles
Les langues disponibles
OPERATING YOUR APPLIANCE
Temperature Control
Your beverage cooler has one control for
•
regulating the temperature. The temperature
control is located on the top center of the
beverage cooler compartment.
The first time you turn the unit on, adjust the
•
temperature control knob to "7" and run for at
least 2 hours before putting beverages
inside. This will ensure the cabinet is thoroughly chilled before beverages is stored.
The range of the beverage cooler temperature control is from position "1" the warmest to "7" the
•
coldest. Adjust the temperature control to the setting that best suits your needs.
To turn off the beverage cooler, please turn the temperature control knob to "0". Please note that
•
turning the temperature control knob to "0" position stops the cooling cycle, but does not
disconnect the power supply to the beverage cooler.
WARNING: Do not set the temperature control to setting of "7" position for longer than 8 hours.
If the unit is unplugged or loses power; you must wait 3 to 5 minutes before restarting the unit. If you
attempt to restart before this time delay, the beverage cooler will not start.
Change in ambient temperature will affect the internal temperature of the beverage
•
cooler.
If you choose to change the thermostat setting, adjust thermostat control by one
•
increment at a time. Allow several hours for temperature to stabilize between
adjustments.
Changing The Interior Light
Before removing the interior light, turn off the beverage cooler first and then unplug the unit from the
wall outlet. Failure to do so could result in electrical shock or personal injury.
Use Phillips screwdriver to take out the screw holding the transparent light cover.
•
Remove the transparent light cover gently.
•
Pull out the existing light bulb by unscrewing it counter-clockwise.
•
Insert new light bulb (E12, max. 15W) by screwing it in clockwise.
•
Replace the transparent light cover and tighten screw.
•
Automatic Defrost
There is no need for manual defrosting of this beverage cooler due to automatic defrosting function.
The ice build-up on the inner back wall during compressor operation will be automatically
•
defrosted once the compressor cycle is off.
Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan
•
located above the compressor, from where it evaporates.
All manuals and user guides at all-guides.com
6
EN
Publicité
