Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
WARNING
Read all instructions before using the beverage cooler.
•
DANGER or WARNING: Risk of child entrapment.
•
To avoid the possibility of child entrapment, please take the following precautions
•
before throwing out the beverage cooler.
-
Remove all doors from the unit.
-
Leave the shelves in place so that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the beverage cooler.
•
Refrigerants: All refrigeration products contain refrigerants, which under the
•
guidelines of federal law must be removed before disposal of product. It is the
consumer's responsibility to comply with federal and local regulations when
disposing of this product.
Never clean beverage cooler parts with flammable fluids. The fumes can create a
•
fire hazard or explosion.
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
•
of this or any other appliance. The fumes can create a fire hazard or an explosion.
INSTALLATION INSTRUCTIONS
Before Using Your Beverage Cooler
Remove the exterior and interior packing.
•
Before connecting the beverage cooler to the power source, let it stand upright for approximately
•
4 hours. This will reduce the possibility of a malfunction in the cooling system from improper
handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page 7)
•
Installing Your Beverage Cooler
This beverage cooler is designed to be free standing only, and should not be recessed or built-in.
•
Allow 5 inches of space between the back and sides of the beverage cooler, which allows the
•
proper air ventilation. Adjust the feet to keep the beverage cooler level.
Locate the beverage cooler away from direct sunlight and sources of heat (stove, heater, radiator,
•
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Ambient temperature below 55°F (12.8°C) or above 77°F (25°C) will hinder the
performance of this appliance. This unit is not designed for use in a garage or any other
outside installation.
Avoid locating the beverage cooler in moist areas.
•
Plug the beverage cooler into dedicated, properly installed-grounded wall outlet. Do not under any
•
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center. This unit is not designed to be installed in an RV or used with an
inverter.
After plugging the beverage cooler into a wall outlet, turn the unit on and allow the unit to cool
•
down for 3 ~ 4 hours under before placing beverages in the appliance.
All manuals and user guides at all-guides.com
To reduce the risk of fire, electrical shock,
or injury when using your appliance, follow
these basic precautions:
-Save these instructions-
4
EN
Publicité
