Lelit PS25 Mode D'emploi page 4

COMPONENTS:
1. Safety cap
2. Wand seat
3. Boiler switch
4. Iron switch
5. Low water indicator light
6. Steam regulation knob
7. Temperature regulation knob
8. Steam button
9. Iron plate
10. Gauge
USER INSTRUCTIONS:
1. Remove the ironing machine from its packing and make sure all packing parts have been taken
off (including the protection bags). Lay the machine on a flat and steady surface fitted to support
it next to a wall socket (max. mt. 1,5).
2. Insert in the wand seat (2) the supplied wand to hold the hose up and hook it with the spring up
to the iron-boiler connecting wire.
3. Unscrew the safety cap (1) and let the internal air out. Fill the boiler with max. 2,0 liters of water,
use the funnel supplied, making sure you do not overfill the tank. Close the safety cap (1).
4. Insert the plug into an electrical outlet; switch on boiler (3) and iron switch (4). If the two
buttons come on, iron and boiler are working.
5. Turn the iron plate's temperature regulating knob (7) to the position "cotton °°°" (indicated on
the iron knob).
6. Wait that the boiler switch's red light (3) goes off (it takes about 10 minutes). While ironing, the
boiler switch's red light (4) normally comes on.
7. The machine is ready for use.
8. Push the steam button (8).
9. It is possible to regulate the quantity of steam by the steam knob (6) – only for the models
PS05/B and PS09/D
10. In case the steam stops during ironing and the low water light indicator (5) comes on, it means
that there is not enough water in the tank. To start ironing again, switch off the boiler switch (3);
press the steam iron button (8) to ensure there is no more steam in the boiler, slowly open the
pressure cap (1), disconnect the plug and refill to the required level. Fill the boiler with warm
water and wait for it to build up pressure again.
11. When you first press the steam button (after having turned the boiler on and depressed the
steam button on the iron) you might notice a decrease in pressure. This is because the tank has
air in it. In order to have plenty of steam (after you have depressed the iron) wait until the
pressure goes back up to the maximum level before you begin.
12. It is possible to check the inner pressure level of the boiler by means of the pressure gauge (10)
– only for the model PS09/D.
CAUTION:
This appliance is not intended for use by persons (including children) with reduced physical,
-
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they do not play with the appliance.
-
The iron is not to be used if it has been dropped, if there are visible signs of damage or if it is
-
leaking.
Do not leave the machine unattended while the plug is connected to the socket.
-
The iron reaches very high temperatures and it keeps being very hot even 15 minutes after it's
-
been switching off. Be careful not to burn yourself.
For complete safety, before filling the boiler, please disconnect the plug.
-
While using the machine and 15 afterwards the iron plate (9) has very dangerous temperature –
-
do not touch it.
While using the machine, never unscrew or remove the cap (1) while under pressure. Before
-
removing it, make sure that it does not give off steam anymore by shutting the boiler off, and
pressing the steam iron button (8) to release all remaining steam.
The machine has a special heating element. Only qualified technician should replace it.
-
The safety cap (1) must be replaced with original parts only.
-
All manuals and user guides at all-guides.com
English