Lelit PS25 Mode D'emploi page 5

PLEASE NOTE:
The use of normal tap water is recommended. In order to clean the boiler and remove limestone, rinse it
internally (every 15-20 liters of water used or every month) only with tap water.
TECHNICAL DATA:
Adjustable iron thermostat set from 60°C to 215°C
Bimetallic safety iron thermostat with manual reset at 275°C
Heating element:800W (Version 230V: 50Hz / Version 120V: 60Hz)
Boiler power : 1000W (Version 230V: 50Hz / Version 120V: 60Hz)
Working pressure: 2,5 bar
Max. pressure: 5,5 bar
Tank nominal capacity: 2,5 liters
PROBLEM CAUSE
It may happen that, while filling the tank,
Few steam comes out some water spills over the cap and flows
of the boiler inside the boiler wetting the insulating
material
While filling the tank you may have poured
Steam mixed with
too much water into it.
water comes out of the
iron
The iron plate is not hot enough
The steam knob might be closed
The iron switch might be off
There is no steam
coming out of the iron
The boiler switch might be off
The water might be over (the low water
light indicator might be on)
The ironing board cover might not be able
to absorb the steam completely
The ironing board gets
wet
The steam iron leaks steam mixed with
water (check by spraying some steam on
a dry cloth)
Dirty water comes out Maybe some dirt got into the boiler
of the iron together with the water.
The inserted data and pictures can be subject to changes without previous notice for the improvement of
the machine's performances.
All manuals and user guides at all-guides.com
SOLUTION
In order to solve the problem, we suggest
using the machine as usual so to dry up the
insulating material through the heat of the
machine. In case you still have this
problem after one working hour, please
contact the service shop
The problem will go on until the excess
water is over. Keep the steam button
pressed until the water in the tank is at the
correct level.
Please check that the temperature knob is
on the right position: "cotton °°°)"
Open the steam knob (on models PS05/B &
PS09/D only)
Switch on the iron switch and the relative
led will come on; wait for 4 minutes so that
the iron plate gets warm enough
Switch on the boiler switch and the relative
led will come on; wait for 10 minutes so
that the boiler can generate steam
Fill the boiler with water following the
instructions
You might use a thicker cover (or two
covers) so to create a thicker surface to
absorb the steam better. In case you are
using a vacuum table, switch on the
vacuum function each time you are using
the steam
Please see above paragraph "Steam mixed
with water comes out of the iron"
Fill the empty tank with 1 litre of water,
screw the cap up, shake it, open the cap
and empty the tank. Repeat this process
until the water is clean. We do not
recommend the use of any additive. Before
ironing again spray some steam on a cloth
until clean steam comes out.
English