NORSKE NMAP004 Manuel D'utilisation page 4

CUTTING
CUTTING
Insert material between the cutting blade
and the base, flush with the aluminum
fence (Fig. 4-A) and hold the material with
foot then push handle down to complete a cut.
WARNING! Maintain control of the handle.
Do not allow handle to slam back after
making cut.
REPEAT CUTS
The laminate flooring cutter is equipped
with an adjustable measuring gauge
(Fig. 5-A) for quick repetitive cutting.
Loosen knob (Fig. 5-B) and slide gauge to
desired cutting length; tighten knob to lock
measuring gauge in place.
Insert material between the cutting blade
and the base, flush with the aluminum
fence; and tight to the measuring gauge.
Hold the material with foot then push
handle down to complete a cut.
WARNING! Maintain control of the handle.
Do not allow handle to slam back after
making cut.
ANGLE CUTTING
Insert the material between the cutting
blade and the base. Using the markings on
the table top (15*/22.5*/30*/45*), lineup
the board with the appropriate line to get
the desire angle (Fig. 6). Hold the
material in place with foot then push the
handle down to complete the cut.
WARNING! Maintain control of the handle.
Do not allow handle to slam back after
making cut.
WARNING! Do not put your fingers against
the sharp edge of the blade at any time.
All manuals and user guides at all-guides.com
B
- 4 -
A
FIGURE 4
A
FIGURE 5
FIGURE 6
WARNING
VERY SHARP BLADE