Publicité
Les langues disponibles
Les langues disponibles
Inserting the batteries
1
Open the remote casing.
3
Close the housing
Auto Standby
The energy consumption of this device in operation mode and in the
standby mode has been reduced. Therefore, if no action is recorded
after four hours, the unit will automatically enter standby mode. Simply
press.
The TV comes with its separate furniture carrier. To install the TV table
stand, please complete the installation by following the instructions
below.
1. The panel can be easily scratched, so be sure to: Place a soft cloth
on the table and place the TV face down on the cloth.
Note: Always first unplug the power cord when installing / removing
the stand.
2. Take the base. Please align the base screw holes and the TV and
insert the screws into the holes in the base and tighten.
Note: To make sure the TV is stable, please lock all the screws.
Support for some TV models is designed with snap type, easy to
install, slamming into the groove of the support instead of the screw.
2
Insert two LR03 batteries (AAA) observing the
+/- indicators (plaice not included).
Remarks:
- Remove the batteries from the remote in
case of prolonged non-use.
- Wash your hands after handling the batteries.
- Remove the batteries in collection bins
(please ask your dealer) to protect the
environment.
Note: Batteries are not included.
BASE INSTALLATION
EN-14
Publicité
