BRIGHT 021131 Traduction Des Instructions D'origine page 31

TROUBLESHOOTING
Problem Possible cause
Nothing happens
after pressing
the "Vacuum &
Seal" button.
Air does not
pump out of the
bag.
The sealing strip gets too hot
The bag melts.
when sealing.
Action
Check that the plug is plugged in.
Check that the power cord or plug is not
damaged.
Use another appliance to check that the
power point is live. If the power point is
not live, check the fuses.
Check that the vacuum bag has been
correctly placed in the vacuum chamber.
Press the lock buttons on both sides and
close the lid.
Allow the vacuum sealer to cool for
25 minutes and try again.
Check that the bag is not creased and
that there are no holes, etc.
Check that the top and bottom seals
on the vacuum chamber are not loose,
cracked or worn.
Food with a high liquid content can cause
the bag not to seal properly. Open the
bag, wipe the top inside clean and seal
again.
Check that the bag is correctly inserted in
the vacuum chamber.
Check that the bag has been put in right.
When sealing bags on a roll, check that
the cut off end is placed on the sealing
strip.
Allow the vacuum sealer to cool for at
least 20 seconds between seals. If the
bag still melts, allow the vacuum sealer to
cool for 25 minutes with the lid open and
try again.
EN
31