AUDIOropa PROLOOP C Mode D'emploi page 14

4.1 Connecting the induction loop
Connect the ends of the loop wires to the terminals (10) on the back of the amplifier.
Single loop
Please note the following information:
• The loop amplifier must be located outside of the loop.
• Twist the cable section between the amplifier and the loop (feed cable to the loop) to
prevent interference.
• Use a suitable measurement device (e.g. ohm meter) to make sure that the loop doesn't
have a short-to-ground (no damage on the insulation of the loop wiring)!
• The distance from the loop level to the normal listening level should be approx. 1.20 m
to 2.00 m.
4.2 Notice for 19" rack installation
5.1 Verstärker konfigurieren
14 English
Double loop
Remove the 3 screws on the forward area of the left and right
sides of the PROLOOP C.
Use the removed screws to fix the 19" rack mounting pla-
tes on the forward areas of the left and right side of the
PROLOOP C.
Unbalanced
Shield / GND
Signal to Pin 2 or 3
Balanced
Shield / GND
Signal to Pin 2 and 3