RS Pro RS-170 Manuel D'instructions page 4

Datalogger/English
BATTERY REPLACEMENT
Only use 3.6V lithium batteries. Before replacing the battery, remove the model from the
PC.
Follow diagrammatic and explaination steps 1 throught 4 below:
1. With a pointed object (e.g. a small screwdriver or similar), open the casing. Lever the
casing off in the direction of the arrow.
2. Pull the datalogger from the casing.
3. Replace/Insert the battery into the battery compartment observing the right polarity.
The two displays briefly light up for control purposes (alternating, green, yellow, green).
4. Slide the datalogger back into the casing until it snaps into place. Now the datalogger
is ready for programing.
NOTE:
Leaving the model plugged into the USB port for longer than necessary will cause some
of the battery capacity to be lost.
1
2
WARNING: Handle lithium batteries carefully and observe warnings on battery
casing. Dispose of in accordance with local regulations.
Sensor Reconditioning
Over time, the internal sensor may be compromised as a result of pollutants, chemical
vapors, and other environmental conditions which can lead to inaccurate readings. To
recondition the internal sensor, please follow the procedure below:
Bake the Logger at 80°C (176°F) at<5%RH for 36 hours followed by 20-30°C (70-
90°F) at>74%RH for 48 hour ( for re-hydration).
If permanent damage to the internal sensor is suspected, replace the logger immediately
to insure accurate readings.
4
All manuals and user guides at all-guides.com
4
3
02/12/2017 Version No. 001
Manuel d'instructions
RS-170 & RS-171
No d'inventaire: 146-9094 & 146-9095
Enregistreur de données
FR