Soozier A91-178 Mode D'emploi page 15

STEP 8
1) Attach the end with stopper ball of Cable for Lower Pull Bar (65) to the open bracket of
Leg Curl (7), around the under side of Pulley (48), tighten the Pulley(48) with the bracket
by X1 Hex Head Bolt (28) through X2 Plastic Bushing (46) (each side), X2 Falt washer(24)
(each side) and X1 Nylon Nut (38).
2) Draw the Cable (65) through the opening space on the lower part of Upright Support
Tube (2), around the Pulley (48) from under side then attach the Pulley (48) to Bracket on
the Base Frame (1), tighten by X1 Hex Head Bolt (26) and X1 Nylon Nut (38).
3) Draw the Cable (65) upward and around the upper side of Pulley (48). Attach the Pulley
(48) to the under side of the Bracket for Pulley (16), tighten by X1 Hex Head Bolt (26) and
X1 Nylon Nut (38).
4) Draw the Cable (65) downward and around the under side of Pulley (48). Attach the
Pulley (48) to bracket on the Base Frame (1) and tighten by X1 Hex Head Bolt (26) and X1
Nylon Nut (38).
5) Draw the Cable (65) upward and around the upper side of Pulley (48). Attach the Pulley
(48) to the under side of Bracket for Pulley (20) set and tighten by X1 Hex Head Bolt (26)
and X1 Nylon Nut (38).
6) Draw the Cable (65) downward and connect with bracket on Base Frame (1) by Chain 7
Links (59) and X1 Hook (61). Note: Adjust the Cable (65) to be tighten enough and lock on
certain position of Chain (59) by Hook (61).
7) Attach the Lower Pull Bar (14) to the front end of Cable (65), connecting by Chain 6
Links (59).
15