Suggested Settings - Omnitronic CL-166 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The following diagram shows how the ATTACK/RELEASE works. Different time settings will create different

effects. Expample: INPUT LEVEL 10 dB at 4 dB compression

10. LEVEL Control

To adjust the channel or overall output level. Adjust this control to vary the amount of fixed gain in the

CL-166's output amplifier stage. This control is especially useful to compensate for RMS level decrease wich

results from the unit's dynamic processing effects. After you adjust the CL-166's controls for desired amount

of compression, set the Level-control to add the same amount of gain that is shown on the Gain Reduction

meter. For example, if the average amount of gain reduction shown on the meter is 10 dB, then setting the

Level control to 10 dB will compensate for the 10 dB average level reduction at the output.

11. LED LEVEL Meter

Lets you keep an eye on the signal level in order to avoid distortion.

12. BYPASS Selector

This switch allows instant comparison of the original sound with the equalized sound. Note that the Bypass

mode works independently for each channel, even if the unit is stereo-coupled (via the Stereo/Link button).

13. STEREO / LINK Button

This button toggles the unit between stereo and dual mono operation. Press the Stereo/Link button IN for

stereo operation where CH A becomes the master controller for both channels. All of CH B's controls,

buttons and LEDs will be disabled (except for CH B's Bypass button and Gain Reduction LEDs), as CH B is

the „slave". With the Stereo/Link button OUT, the unit works as two separate mono compressor/gates, each

with its own independent controls.