Power Led - Marmitek GIGAVIDEO800 Guide Utilisateur

POWER LED

Source LED
Red OFF
Blinking Blue N/A
Blinking 3x
per second **
Blinking 1x
Blue
per second
Solid blue
* Signal strength indicator (0 = no, 1 = weak, 2 = average and 3 = strong signal)
** It's normal to see the Source LED blinking when you switch your AV sources.
CHANNEL FREQUENCY
If you have some electronic devices like cordless phone, wireless access point/ router
used with 5GHz channel frequency near the GigaVideo800, you may experience
no/noise picture or diminished sound quality. Press the CHANNEL button three
seconds to adjust to an appropriate channel for GigaVideo800.
1. Enter wireless RF channel adjustment mode
Press the CHANNEL button three seconds. The all SOURCE LED 1-4 will blink 3 times
to show the current RF channel.
2. Changes to the next RF wireless channel
Press the CHANNEL button again. The SOURCE LED will automatic show the current switched RF channel.
RF Channel; Frequency (MHz)
# 32
# 36
# 40
# 44
# 48
3. Exit the wireless RF channel adjustment mode
There is no button on the remote pressed about 10 seconds.
6
Mode
Standby
Warm-up
No connection *
Connected *
LED status
5160
5180
5200
5220
5240
Status
In standby mode
Setting up connection between transmitter and receiver
Transmitter and receiver out of range or one of both has been
switched OFF
Input from selected source device is not detected.
Unrecognized video format.
(Not support or out of range.)
Recognized video format.
LED blinking number
12
13
14
23
24
GIGAVIDEO800 HDMI™