dirna Bergstrom LITE Serie Instructions De Montage page 17

LITE
is not resistant enough (if roof is made of
fibre, plastic, etc...), it is the installer who will
have to decide, under his responsibility, if it
is necessary to reinforce the roof to avoid
possible deformations, breaks, water entries,
etc., habilitating the means required to stop it
from occurring.
- Unit pre-charged with r-134a refrigerant gas.
- Important: When connecting the unit make
sure the polarities are not reversed. If this
happens, the control board will not switch on
and the unit will not operate.
Tools required for assembly
- Torx wrenches set.
- Allen wrenches set.
- Open-jawed spanner 10, 13, 14
- Scissors.
- Flexo-meter.
- Screwdriver.
Proper use of the product
- LITE is a roof-mounted air conditioning unit
suitable only for use in trucks. It is not suitable
for installation and operation in agricultural
or construction machinery subject to intense
vibrations.
- Non-intended use will void the unit's warranty
and exempts the manufacturer from any
responsibility.
- If you are not sure how to use LITE, read the
product's user manual.
- If the temperature in your vehicle's cab is
too high for rest, first cool the cab with your
vehicle's air conditioning for a few minutes
and then run LITE to maintain the comfort
temperature.
Associated documentation
- User manual: 1002430116
- List of spare parts: 1003118747
- Troubleshooting: 1002430117
Dirna Bergstrom declares that the LITE unit
complies with the requirements of the following EC
Directives and that the harmonised standards and
technical specifications listed below have been
applied:
- EC Directive 2014/53/EU
- EC Directive 2011/65/EU
- EC Directive 2014/30/EU
17
EN