Publicité
Les langues disponibles
Les langues disponibles
Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
To prevent injury to the user or other people and property damage, the following instructions must be
followed. Incorrect operation resulting from ignoring these instructions may cause harm or damage.
ENERGY SAVING
TIPS
OPERATING
CONDITIONS
TOOLS FOR
WINDOW KIT
INSTALLATION
Identifying Parts
ELECTRICAL INFORMATION
•
Do not store or use gasoline or other fl ammable vapours and liquids in the vicinity of this or any other
appliance.
•
Avoid fi re hazard or electric shock. Do not use an extension cord or an adaptor plug. Do not remove any
prong from the power cord.
•
Be sure the electrical supply is adequate for the model you have chosen. This information can be found
on the serial plate, which is located on the side of the cabinet and behind the grille.
•
Be sure the air conditioner is properly grounded. To minimize shock and fi re hazards, proper grounding
is important. The power cord is equipped with a three-prong grounding plug for protection against
shock hazards.
•
Your air conditioner must be used in a properly grounded wall receptacle. If the wall receptacle you
intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker, have a
qualifi ed electrician install the proper receptacle.
•
Ensure the receptacle remains accessible after the unit is installed.
All manuals and user guides at all-guides.com
•
Use the unit in the recommended room size.
•
Locate the unit where furniture cannot obstruct the air fl ow.
•
Keep blinds/curtains closed during the sunniest part of the day.
•
Keep the fi lters clean.
•
Keep doors and windows closed to keep cool air in and warm air out
(cooling mode)
The air conditioner must be operated within the temperature range
indicated below:
MODE
COOL
DRY
Note: Performance may be reduced outside of these operating tempera-
tures.
1. Screwdriver (medium size, Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Saw (In the event that the window kit needs to be cut down in size
because the window is too narrow for direct installation).
See www.danby.com for general instruction guide
WARNING
WARNING
3
ROOM TEMPERTURE
17°C (62°F) ~ 35°C (95°F)
13°C (55°F) ~ 35°C (95°F)
Publicité
