Stopping The Engine; Starting With Warm Engine; Working With The Earth Auger - Nemaxx EB52 Mode D'emploi Original

KEN002EB52
Do not fully pull out the cranking rope and slowly guide the cranking handle
back to make sure that the cranking rope is correctly wound up
• Repeat this operation until the engine starts.
• Put the choke lever (B) halfway back when the engine has started.
• The engine will idle when you release the throttle trigger.

Stopping the engine

Release the throttle trigger (D).
Put the ON/OFF switch to the position [ O ] OFF (STOP)

Starting with warm engine

• Set the choke lever (B) to ON.
• Press the throttle lever with the right hand.
• Pull the starter cable quickly and evenly with the left hand.
Let it slide back slowly after each pull

WORKING WITH THE EARTH AUGER

• Only use auger drills recommended by the manufacturer.
Pay attention to the max. diameter.
• Put your feet shoulder-width apart and firmly grasp the earth auger on both handles.
• Start the drilling with „half throttle" and gradually increase the speed so that the drill
penetrates into the soil without any problems.
• Drill holes without exerting too much body weight on the auger. Allow the auger to
advance by its own weight.
• If the auger drill is jammed in the soil and cannot be pulled out, stop the engine and turn
the earth auger counterclockwisely.
• The clutch may still slip during the run-in time of approx. 2 operating hours.
Make sure that the clutch is free from oil or moisture.
EN
16
v04 • 22.05.2017