Start-Up; Starting With Cold Engine - Nemaxx EB52 Mode D'emploi Original

KEN002EB52

START-UP

• Check that the machine is completely and correctly assembled
• Before each use, check:
- the correct assembly of the drill
- the machine for possible damage
- loose fastenings.
The engine of the machine is supplied without gasoline and oil in it. Fuel the device as
described under "Fuelling".
When starting make sure that the drill can freely rotate.

Starting with cold engine

• Put the choke lever (B) to OFF
• Firmly press on the fuel pump (A) several times until petrol (gasoline) / foam is visible in
the priming pump
• Put the ON/OFF switch to [ I.] ON
• Press the throttle trigger (D)
• Grasp the cranking handle (C) and slowly pull the cranking rope until a resistance is felt.
Then, pull quickly and firmly.
EN
15
v04 • 22.05.2017