Master PROHEAT Série Mode D'emploi page 12

1500/ 2500 LCD Programmable Heat Gun
PH-1500/2500
Operating Instructions
HEAT
1) Plug heat gun into properly rated outlet.
2) For COOL temperature, press the switch to
the center position (I).
3) For HEAT, press the switch to the high
position (II). It is important to press the switch
progressively through each position. If you
COOL
press directly from O to II, the heat gun will not
operate and 'OFF' will show in the display. If
this happens, return the switch to O then press
to I and then to II.
4) To adjust the airflow, press the up/down
arrows on left side of keypad. To adjust
OFF
temperature, press the up/down arrows on
right side of keypad. The number of bars
above the arrows in the LCD correspond to the
amount of airflow and temperature.
5) For OFF, press switch to the O position.
12
www.masterappliance.com