Aiwa VX-C131U Mode D'emploi page 5

PREPARATION
Connecting the antenna
Basic connections
1
Connect the antenna cable to the VHF/UHF connector on the unit.
If the cable is a round-type 75-ohm coaxial cable, connect it directly to the VHF/UHF connector.
If the cable is a flat-type 300-ohm twin-lead cable, connect it to the antenna adaptor (supplied), and connect the adaptor to
the VHF/UHF connector.
The antenna adaptor can be taken out from the supplied telescopic antenna.
2
Connect the AC cord to the AC wall outlet after passing it through the AC cord hook.
To connect the supplied telescopic antenna
Antenna adaptor
(supplied)
Mount the supplied antenna in the antenna holder.
Extend and adjust the ends of the antenna to get the best signal reception.
Note
For better reception, especially in outlying areas, or where ghosting or interference is a problem, use an external room-mounted
antenna.
AUDIO VIDEO
R L
(MONO)
OUT
VHF/
UHF
IN
2
AUDIO VIDEO
OUT
VHF/
UHF
IN
75-ohm
coaxial cable
(not supplied)
1
AC cord hook
To AC outlet
o
300-ohm twin-lead cable
(not supplied)
Antenna adaptor
(supplied)
CONTINUE
4
ENGLISH