Télécharger Imprimer la page

Sunred RSH16 Instructions D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

Minimum Required Distances
25cm from the side wall
50cm from the ceiling
installation height above 180cm
Operation
Connect the power cable to a 13 amp supply which is located in a safe, dry area.
To operate the heater on 2100W power, pull the switch cord once.
To off the heater, pull the switch cord again.
Although the patio heater is waterproof, do not use when raining or in wet conditions.
Never connect the power cable from the electrical supply, when the patio heater is not in use.
MAINTENANCE
Unplug the unit and let it cool completely.
To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mile detergent if
necessary. After cleaning, dry the unit with a soft cloth.
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause
damage or deterioration to the surface of the heater.
Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety. Wait until the unit is
completely dry before use.
STORAGE
If the heater will not be used for a long period of time, store it in a cool, dry location when not in use. To prevent dust and dirt
build-up, use the original packaging to repack the unit.
TROUBLE SHOOTING
If the heater will not operate, please check the following before seeking repair of service:
Check if the power cord is plugged into an electrical outlet, if not plug in.
Check if electricity to the main fuse is working.
Make certain the power switch is turned on. If not, choose a setting.

Publicité

loading